mrfunkyjay
New Member
many thanks to all that helping me out. I am going to try each approaches.
Anyway, to answer Mike question. For the throttle trigger, Actually I want to simulate "Braking" signal for a car light. It is 50% initial brightness, and when the pulse is more than 1.6ms (braking signal), it is in 100% brightness. But here I just make the LEDs flash in a sequence (for example only) then it is just applicable.
My problem is still, difficult to have both flashing modes for steering and throttle triggers run at the same time (well not at the same time, but almost the same time). A solution to this is to use 2 PICs but it is hardware approach, since I want to study and learn PIC Programming, would really learn, then it should not be that way. Many thanks to all.
Kind regards,
Kelvin
Anyway, to answer Mike question. For the throttle trigger, Actually I want to simulate "Braking" signal for a car light. It is 50% initial brightness, and when the pulse is more than 1.6ms (braking signal), it is in 100% brightness. But here I just make the LEDs flash in a sequence (for example only) then it is just applicable.
My problem is still, difficult to have both flashing modes for steering and throttle triggers run at the same time (well not at the same time, but almost the same time). A solution to this is to use 2 PICs but it is hardware approach, since I want to study and learn PIC Programming, would really learn, then it should not be that way. Many thanks to all.
Kind regards,
Kelvin