Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
If the output of this amplifier is shorted or has a load resistance too low then the gate-source voltage could become higher than the maximum allowed for the Mosfets. The zener diodes limit the maximum gate-source voltage to 9.1V.
Hello mr Audioguru,
The starting point for me is the highest possible quality, and that is not possible with an ic I think.
Have in the past tried but it was never comparable to a discreet built preamplifier.
The output voltage of an average CD player is around 1 volt, which is the reason that I with 1 volt input voltage test.
See also prefer the output of a tuner, or a turntable that light a little more at a lower level than the CD player.
There are many excellent audio opamps such as the OPA2134 dual that has distortion of only 0.00008% and very low noise. Audiophools think its distortion is too high! You might be able to hear 0.1% distortion on music if you have good hearing.
The last time I played my turntable was about 20 years ago and its high gain preamp uses a Japanese audio IC that sounds great.
Your preamp has a gain of 7.7 times so if its output of 7.7V feeds a power amp with a gain of 20 then the output power into an 8 ohm speaker is 3kW! If you use a piece of wire as a preamp then it has no distortion and the 1V output of a CD player into a power amp with a gain of 20 produces a reasonable 50W into 8 ohms.
Why does your preamp have such a high supply voltage?
The gain goes down, is still in the test.
The high voltage is actually emerged after visiting AJ van den Hul 20 years ago, my preamplifier then had a supply voltage of +18 volts and - 18 volts, he advised me on increasing the supply voltage to 33 volts + and -, which I did and was very positive about the dynamic behavior of the preamplifier.
With the op amps I'm going to set up a test plate.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.