4. Measure a changing signal voltage with the oscilloscope
a. Connect the frequency generator output to the oscilloscope 1X input.
b. Select the square wave output.
c. Set the frequency knob to a value of 1 kHz and turn the Fine Freq knob all the way counterclockwise.
d. On the oscilloscope, adjust the Time/Div setting to a value of 0.5 ms (observe setting at the top of the screen.).
e. Set the Volts/Div to 2.0V.
f. Sketch the observed waveform below. Label both axes and ground.
**broken link removed**
Output Waveform for Step #4
5. Generating and measuring triangle waveforms.
a. Set the frequency generator to output a triangle wave ( **broken link removed** ) with a frequency of 1.0 kHz.
b. Set the oscilloscope to 2.0V/div and 200 μsec/div and sketch the output below. Label the axes and ground.
**broken link removed**
Output Waveform for Step #5
c. Measure and record the values below, including units.
Vertical scale _____________ Horizontal scale______________
Period ________________ Frequency _________________
6. Generating and measuring sinusoidal waveforms.
a. Select a sine wave output with a frequency of 1 kHz.
d. Record measurements displayed on the oscilloscope display, including units.
Vertical scale _____________ Horizontal scale______________
Peak +V = _______ Frequency = ________________