Hi there,
I am a University student in Australia and am currently trying to find a microcontroller to suit this application.
I have two serial devices one a mobile phone that requires 9600 baud that will need to receive and send data to and from the uC. The other device is a GPS receiver that sends characters to the uC at 4800 baud.
I guess my first question is there any ideas on a low cost uC that would do the job?
I was also wondering how in the software I could store the bytes as messages from the phone could be as long as 25+ bytes I have done some uC programming of the serial port however it was only sending of data not receiving. Can anyone point me in the direction of where to start in this area?
Thanks Heaps,
Allan.
I am a University student in Australia and am currently trying to find a microcontroller to suit this application.
I have two serial devices one a mobile phone that requires 9600 baud that will need to receive and send data to and from the uC. The other device is a GPS receiver that sends characters to the uC at 4800 baud.
I guess my first question is there any ideas on a low cost uC that would do the job?
I was also wondering how in the software I could store the bytes as messages from the phone could be as long as 25+ bytes I have done some uC programming of the serial port however it was only sending of data not receiving. Can anyone point me in the direction of where to start in this area?
Thanks Heaps,
Allan.