MCC again.

[Pommie]

I'm trying to setup a chip using the MCC (Microchip Code Configurator)
I setup the I/O pins as I need them,

Note, no idea why random pins (A5, C2 & C3) are set to analogue.
Nothing unusual, Note, A0 & A1 are inputs. I then open the ADC module as I need these pins to be analogue inputs,

Now, the ADC line shows up but also do the weird symbols on A0 - note not A1.
I check the Notifications and I have these warnings,

So I somehow need to change my pins (A0 & A1) to be analogue inputs.
How?
As far as I can see, the pin(s) are setup as analogue input pins.
If I try to double click to make any other pins analogue I get the same symbols.
I.E. double click on ANx-A1 and I get,

Can anyone explain this?
I'm not too worried as I can setup all this after MCC has finished.

Mike.

 

[Pommie]

I found out the answer but I'm waiting to see if it's obvious to others and it's me being thick.

Mike.