LTSPICE simulation of AC/DC converter

You would need a switched-mode controller IC plus separate power devices and drivers for those.

Or use a conventional switch-mode PSU system; control at the 230V AC side of a transformer, and feedback from the lower voltage side after rectification.

That means controlling much lower currents.
 
can you further elaborate on this ..it would e very helpfulas i am new to design .....especialy this statement :You would need a switched-mode controller IC plus separate power devices and drivers for those.
 
where are the switched mode controller ICs available ..can we get a model of it in LTSPICE etc? and what are the power devices and drivers you are talking about? can you give me some example IC numbers for these ??
 
AC-DC converter (230v,AC to 28v DC ,147 A) - it can be readily available IC or design
There is no "single IC" solution, the power rating is orders of magnitude too high.

That system will be handling power input in excess of 4000 Watts - into the range of industrial welding machines and too great a power for normal domestic outlets.

It is a very complex and specialised design, which in a DIY version is very likely to destroy many expensive parts during its development and testing!

This is a commercial PSU with similar ratings, around 170A @ 28V:
(Many "24V" PSUs are adjustable up to 28V).

They are almost 500mm long and weigh around 10Kg!


This the an interior view of a similar but slightly lower power one:



I've been designing electronics as a profession for over 40 years, and I would not consider trying to design anything comparable - it's a very specialised field, and you could well get through many thousands of pounds worth of parts before ending up with a workable product.

It's worthwhile for companies that will be mass-producing them, but not otherwise!
 
could u pls guide ,how to proceed designing the circuit AC-DC (230v AC ,28v,147A DC)
 
could u pls guide ,how to proceed designing the circuit AC-DC (230v AC ,28v,147A DC)
Re-read post #8. You would need to consult a specialist in this field. Expect to pay serious money for the necessary advice. What is your budget for this project?
 
could u pls guide ,how to proceed designing the circuit AC-DC (230v AC ,28v,147A DC)
Simply, NO! The costs and dangers involved are major - and far worse for someone who has little understanding of electronics.

You just do not appear to appreciate the scale of such a task - it's like comparing the work designing a small remote control model car (eg. typical small electronics power supply) to a full size road legal car!


Study these:

ST make some development kits for a 3000W design; there are two parts; these are the data sheets with schematics for each:

First half: The AC input and power factor correction stage:

Second half: voltage conversion - it's for 48V but the only difference would be the transformer windings and feedback components:


Work through each schematic diagram and look up the data for every single part.
 
thanks for the information
 
Cookies are required to use this site. You must accept them to continue using the site. Learn more…