[LT-Spice help]Modifying properties of nodes!

Hi All,

I am using LT-Spice to simulate a circuit based on parallel and series resistances.

I want to define additional (fixed) resistance on each node. That is, in every circuit when two components are connected there is additional contact resistance.

I want to put this contact resistance in my circuit.

Is there a way in LT-Spice to define somewhere a resistance of node itself?

Regards
Rameez
Friedrich Alexander University Erlangen

No. Nodes are just connection points. You add a resistor in series to represent the contact resistance. You can label it Rcontact or something similar to identify it.