Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Low Voltage Heating Element

Status
Not open for further replies.

cks3976

New Member
Hi,

I am looking to build a small heating element for an assay, which should be capable of heating a credit card sized Polypropylene / Glass cartridge to to around 120 degree F (50 Deg C) . I can either use a 9V or 12V source for this.

Please advice.

PS : I am exploring following options:
1. Peltier TEC
2. IR LED array, and
3. Positive PTC with Wire coil
 
In the past I've used **broken link removed** resistors to do this. Easily controlled by a MOSFET.

Mike.
Edit, when you say 9V or 12V, you will need a substantial (5A) power supply for this - not a battery.
 
The simplest thing for a fairly low temperature like would just be a few power resistors stuck or bolted to a piece of aluminium sheet.

As it happens, I have a virtually identical device in my "to do" list. These are the ones I got, a pack of five 33 Ohm 17 Watt power resistors:
Resistor_Bank_33R.jpg

They are each around 75mm long and 10mm wide.

On 12V, each resistor dissipates around 4.4W, so all together 22W if you used all five (around 2A at 12V). I was going to use four with a small gap in the centre and a temperature sensor, then PWM control, but if it's not to a few degrees you could use a simple mechanical thermostat.

[Pommie beat me to it with the same basic idea, while I was transferring the photo from my phone].
 
Light bulbs get hot without using much power.
 
I would bolt one of these 30 ohm resistors

to the bottom of a 1/8" aluminum plate the size you need then insulate the resistor and the rest of the bottom of the plate. Then power with 12VDC. You'll get about 400mA and 5W. It will take a bit of time to stabilize. You should add a PWM controller to trim to the power needed to minimize overshoot when used with a thermostat. Add a thermostat and PID control logic with a temp sensor and it will be spot on.

the more logic you add, the greater current can be used to heat and keep the temperature in your desired zone.

1603632054962.jpeg

 
Thank you all for your feedback. I think the resistor option seems best from both operation and cost point f view. I will try the same. Thanks again
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top