Hello,
I'm working on a rotating POV display and I got my self a DC motor from kid's toy ride-able ATV.
I assumed it was 12v operated, I measured 1Amp going through it without a load attached to it.
Anyways, I just realized it had it's model written on it:
"RS-550SH
JD020307" - Second line is really hard to read so i'm not 100% sure it says that.
Anyways, I googled for the first line and bingo - the first two matches are:
**broken link removed**
#2
But both of these have conflicting info. I tend to believe the pdf more but it has two columns of values as if two models exist and I don't know which one I have.
Anyways, how should I power it if I want to use it for my spinning POV display which weights approx 300g ? I don't need it to spin any faster than 1800 RPM.
Thanks in advance,
Mike.
I'm working on a rotating POV display and I got my self a DC motor from kid's toy ride-able ATV.
I assumed it was 12v operated, I measured 1Amp going through it without a load attached to it.
Anyways, I just realized it had it's model written on it:
"RS-550SH
JD020307" - Second line is really hard to read so i'm not 100% sure it says that.
Anyways, I googled for the first line and bingo - the first two matches are:
**broken link removed**
#2
But both of these have conflicting info. I tend to believe the pdf more but it has two columns of values as if two models exist and I don't know which one I have.
Anyways, how should I power it if I want to use it for my spinning POV display which weights approx 300g ? I don't need it to spin any faster than 1800 RPM.
Thanks in advance,
Mike.