Logic Gate Selection

Hi,

I used 74HCT86 XOR gate in my circuit.At the output, I expect 0 or 5v according to input values.But I obtain irregular waweforms when motor change direction of rotation. Inputs of 74HCT6 are Hall1 and Y1 and output is Y2.How I can eliminate these irregular waveforms from Y2?
Regards

By having exact timing between changes on the two inputs. Otherwise there will be these glitches.

Anytime the two inputs are changing at approximately the same time, you will get glitches.
You have to arrange the hall sensors so the two signal edges don't overlap for either motor direction.

Hi,

I designed a circuit to control motor direction and rotation. I can get correct outputs, but I want change a point in circuit. Motor turns slow and I want to use some logic gates and thick hall signal output pulses without change rpm. Therefore I need select logic gates to get more closely hall signals. I added circuit below and H1, H2 and H3 are hall signal outputs. Firstly motor turns clockwise and then it turns to counterclockwise. How I can obtain more thick hall signals?
Regards,

One thread on the same subject is enough!!!