Dr_Doggy
Well-Known Member
ok, maybe i will give smt another try , maybe someday when i have a proper pcb for it,, but not going to try to air solder on to my phone wire again!
im using a 1/3hp sump pump, i think it goes up to 6 psi, so far i tested the pump with the 1/2" line only and it shoots about 10-15ft high and about 20ft out on approx 70deg angle, I am hoping it wont blow apart under the pressure, in retrospect i think im going to need expand the nozzles output port to more than 1/8"
I think its going to work ok, one thing i wonder if/where i can get is a bead size lens to narrow the beam a little better
im using a 1/3hp sump pump, i think it goes up to 6 psi, so far i tested the pump with the 1/2" line only and it shoots about 10-15ft high and about 20ft out on approx 70deg angle, I am hoping it wont blow apart under the pressure, in retrospect i think im going to need expand the nozzles output port to more than 1/8"
I think its going to work ok, one thing i wonder if/where i can get is a bead size lens to narrow the beam a little better