Hello ,
I'm new to this forum. I'm using LM16200 lcd interfcing with K60.
I'm able see the signals on data lines operating in 4- bit mode. But if I send wake up command, the response from LCD is "cursor on" . Can anyone suggest me , where the problem i'm facing?
Thanks
Sowmya
I'm new to this forum. I'm using LM16200 lcd interfcing with K60.
I'm able see the signals on data lines operating in 4- bit mode. But if I send wake up command, the response from LCD is "cursor on" . Can anyone suggest me , where the problem i'm facing?
Thanks
Sowmya