Hi,
I'm going to connect the circuit to control step motor using both L297, L298 as in the L297 specification.
A few things i widh to ask:
what should the CONTROL pin's value be: 0 or 1?
WHat's the effect of HALF/FULL Step (provided i use the same CLOCK all the time)? is it correct that i does not change the speed but just have a higher resolution of the motor revolution?
I'm going to connect the circuit to control step motor using both L297, L298 as in the L297 specification.
A few things i widh to ask:
what should the CONTROL pin's value be: 0 or 1?
WHat's the effect of HALF/FULL Step (provided i use the same CLOCK all the time)? is it correct that i does not change the speed but just have a higher resolution of the motor revolution?