Junebug having PICKIT 2 Problems

Can you please tell me the best type of file to use with the Junebug if not a C source file? Thank you

Hello, Swordfish says that it is "unable to locate PIC2CMD.exe Swordfish says that the Junebug was already there.

You need to download and install PK2CMD from Microchips website. It's a simple executable that can be placed anywhere. You then setup Swordfish to find it.

OK, I followed the instructions on page 11 of the Junebug manual and and the Pk2cmd.exe was found. When trying to compile a .bas program again the junebug just sat not responding. Could someone I was given a simple program earlier in this post specifically for the Junebug that also leaves the Junebug just sitting there. I am leaving out steps using Swordfish. Do use VIEW or PROJECT compile and program? Thanks in advance for the help.