Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.
You need to download and install PK2CMD from Microchips website. It's a simple executable that can be placed anywhere. You then setup Swordfish to find it.
OK, I followed the instructions on page 11 of the Junebug manual and and the Pk2cmd.exe was found. When trying to compile a .bas program again the junebug just sat not responding. Could someone I was given a simple program earlier in this post specifically for the Junebug that also leaves the Junebug just sitting there. I am leaving out steps using Swordfish. Do use VIEW or PROJECT compile and program? Thanks in advance for the help.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.