Hello,
I have designed the board that was attached that does voltage amplifying of input signals (4 gain channels) and then conditioning 4 video signals either individually or summed into one and then inserting black level signal when the command signal is zero (coming in from another board, just a square wave signal).
It would be great if I can get some suggestions to improve the design for low noise and crosstalk. This is going to be a two layer board and I tried to keep the signal traces on the top layer as much as possible while the bottom layer is filled with ground plane.
thanks
I have designed the board that was attached that does voltage amplifying of input signals (4 gain channels) and then conditioning 4 video signals either individually or summed into one and then inserting black level signal when the command signal is zero (coming in from another board, just a square wave signal).
It would be great if I can get some suggestions to improve the design for low noise and crosstalk. This is going to be a two layer board and I tried to keep the signal traces on the top layer as much as possible while the bottom layer is filled with ground plane.
thanks
Last edited: