NST
New Member
Hello I am working on a project which use CCP Interrupt.
When I run this code;
CCP Interrupt is not responding until the end of for loop. That means I cannot get response about 26 x 300 ~ 8 seconds.
But I have to stop this loop when a CCP interrupt is inbound.
Help me please.
When I run this code;
Code:
for (i=1;i<27;i++)
{
select(i);
delay_ms(300);
}
CCP Interrupt is not responding until the end of for loop. That means I cannot get response about 26 x 300 ~ 8 seconds.
But I have to stop this loop when a CCP interrupt is inbound.
Help me please.
Last edited: