I've been trying this for the last couple days to no avail. So I figured I'd give the forum a shot. I have all lcd data pins going to Port C and R/W,RS,E to Port A3,A4,A5 respectively. I enable DDRC to output and pulsed E before any changes were made and check to make sure the screen wasn't busy. I basically followed the datasheet but apparently I'm still missing something. If anyone could throw in any advice or suggestions I'd be much obliged!
PS... I'm not looking for anything fancy just clear the screen and write a character to it...hell if I could get the screen cleared I think I'd be styling.
Here is the data sheet for the lcd: https://www.electro-tech-online.com/custompdfs/2006/08/14194op.pdf
PS... I'm not looking for anything fancy just clear the screen and write a character to it...hell if I could get the screen cleared I think I'd be styling.
Here is the data sheet for the lcd: https://www.electro-tech-online.com/custompdfs/2006/08/14194op.pdf