Menticol
Active Member
Hello!
I've found this simple circuit on the net, It's an single channel IR remote control. I hope somebody could find it useful.
The only problem is, I got it from a site with bad reputation of non working schematics - It's pablin.com.ar, to avoid copyright issues.
Should I correct something, before starting etching?
Emmiter
**broken link removed**
Receiver
**broken link removed**
(Receiver needs +9v -9v to work)
Thank you in advance
I've found this simple circuit on the net, It's an single channel IR remote control. I hope somebody could find it useful.
The only problem is, I got it from a site with bad reputation of non working schematics - It's pablin.com.ar, to avoid copyright issues.
Should I correct something, before starting etching?
Emmiter
**broken link removed**
Receiver
**broken link removed**
(Receiver needs +9v -9v to work)
Thank you in advance