dailydriver
New Member
Ok. I'm not a programmer. I've tried to work with PIC's, but got too confused. I've purchased a PICKit II and is still lost.
I'm just looking to get something to work like this:
It's going to have a ground input. I want it to have two outputs with one input. They are all low signals.
I want it to switch between the two outputs everytime the input is seen. Basically, I want it to alternate between the two outputs everytime I trigger the input. All the signals should be low.
I have access to a lot of PIC12F508. If anyone can write me a short code. I would appreciate it. If not, I will buy the pic that the code is written for also. I figured, there isn't much I/O's used, so the 12F508 should suffice.
I'm an electronics technician, but when it comes to coding. I have no clue.
I'm just looking to get something to work like this:
It's going to have a ground input. I want it to have two outputs with one input. They are all low signals.
I want it to switch between the two outputs everytime the input is seen. Basically, I want it to alternate between the two outputs everytime I trigger the input. All the signals should be low.
I have access to a lot of PIC12F508. If anyone can write me a short code. I would appreciate it. If not, I will buy the pic that the code is written for also. I figured, there isn't much I/O's used, so the 12F508 should suffice.
I'm an electronics technician, but when it comes to coding. I have no clue.