How to calculate the Jitter at the output of a DLL circuit after simulation using Mentor Graphics

Hi All,

Anyone can guide me as to how to go about measuring the timing Jitter for the output signal of a Delay-Locked Loop circuit using Mentor Graphics software?,
the input is a square pulse generated by a pulse generator circuit of 100MHz frequency.

Appreciate your kind help. Thanks!

Mentor Graphics has white pares on their web site. My experience with Mentor Graphics was schematic capture with limited board layout. They (Lockheed Martin) had another set of engineers do the layout.

havoc I deleted your post as something went south.... If you need to re-post do so...