My Embedded Application does not do it's intended function because it watchog resets. However, it does do it's intended function in the debugger because I think watchdog is disabled in the debugger.
How do I enable watchdog in the debugger? Will the debugger stop at the instruction causing the watchdog reset? I need to know which instruction is causing the watchdog reset.
My target embedded board is Freescale PowerPC MPC555 Microcontroller based. My software application is loaded and run in this board. My debugger is Lauterbach Trace32.
Thanks.
How do I enable watchdog in the debugger? Will the debugger stop at the instruction causing the watchdog reset? I need to know which instruction is causing the watchdog reset.
My target embedded board is Freescale PowerPC MPC555 Microcontroller based. My software application is loaded and run in this board. My debugger is Lauterbach Trace32.
Thanks.