jesserose85
New Member
Hey Guys,
I am setting up two high power LED units (each one consists of 3 LEDs) link is here Green 3-Up EndorStar - LED Supply.com I am running a 12V 1500mAh battery pack. The driver I am using is a 1000mA Buck Puck link is here: 3021-D-E-1000 BuckPuck - LED Supply.com
I was planning on wiring these in Parallel until I came to this forum and noticed a lot of regular contributors mentioning that Parallel wiring of LEDs is a BAD idea.
Basically I just need to know the best way to get wire these babies up so I can get maximum power.
Also, is there any way I could integrate this product into my setup **broken link removed**
As I mentioned in my last post I would like to be able to control the LEDs.
Thanks a lot people I really appreciate the help.
Jesse Rose
I am setting up two high power LED units (each one consists of 3 LEDs) link is here Green 3-Up EndorStar - LED Supply.com I am running a 12V 1500mAh battery pack. The driver I am using is a 1000mA Buck Puck link is here: 3021-D-E-1000 BuckPuck - LED Supply.com
I was planning on wiring these in Parallel until I came to this forum and noticed a lot of regular contributors mentioning that Parallel wiring of LEDs is a BAD idea.
Basically I just need to know the best way to get wire these babies up so I can get maximum power.
Also, is there any way I could integrate this product into my setup **broken link removed**
As I mentioned in my last post I would like to be able to control the LEDs.
Thanks a lot people I really appreciate the help.
Jesse Rose