Hi everyone, I am a newby
I studied electronics at GCSE and A-Level but didnt really remember to much theoretical stuff and now I have a problem I am sure I can overcome with some help!
I have a set of LED christmas lights that run on UK Mains voltage (not transformered) and they have a flasher unit on but I want to 'by-pass' this and make the set fully static.
Here is photos of the board:
**broken link removed**
**broken link removed**
The input wires are on the top left hand corner.
**broken link removed**
**broken link removed**
I hope you can help me!
Many thanks
Karl Beetson
I studied electronics at GCSE and A-Level but didnt really remember to much theoretical stuff and now I have a problem I am sure I can overcome with some help!
I have a set of LED christmas lights that run on UK Mains voltage (not transformered) and they have a flasher unit on but I want to 'by-pass' this and make the set fully static.
Here is photos of the board:
**broken link removed**
**broken link removed**
The input wires are on the top left hand corner.
**broken link removed**
**broken link removed**
I hope you can help me!
Many thanks
Karl Beetson
Last edited: