Help to all, I am building a desk and am needing help with a circuit. I have designed and built a motor lift using a 90v DC motor and controller. I am using a DPDT switch right now to make the motor go up and down. In that motion I have a switch and either end to stop the motor so it does not crash. I have trying to figure out how I can run this motion at startup of my computer. I was thinking of using power from my powers supply to initiate a relay. Maybe using an LED tab on my board which is 3.3v. I would like to activate it and send the motor up to the top limit switch. Upon shutting down I would like it to go down. I think a changeover relay will work? I just am confused in wiring it. I guess my other concern is if I reset computer I do not want the screens to go down immediately when that led off board opens. So, I dont know if I would need a timer for the down motion. Any help would be great. Thanks.
Last edited: