Help with a capacitor

Hello, I've been working on getting a old directional bar. Old style bulbs,converted to LED's. Thread is Converting Light Bar, by dcsbass.( ) Have Worked out resistors with you all help and especially Mr Sceadwian. But it was suggest to add a capacitor! A small one, maybe 10uf electrolytic, just to buffer the power a little and suck up small surges! To buffer the power from noise and mute short voltage spikes.
I would like any info to figure it out (cap size), or give me formula to do it.
I've been reading the beginner sections. But have not found it yet.
Please I need Help
Thank You very Much

Just put 100u across the power rails

100u for transient suppression? 100u will actually hold the LED power up for a few ms's

colin55 said:

Just put 100u across the power rails

Click to expand...

I don't have any rails. inside the directional bar. Just One 12v supply wire and eight wires to ground for led's (or rather the old bulb socket). Have to run one wire to ground, for Cap.
Can you please how you come up with this figure?


Thank You Very Much

One more thing dcbass. You're doing 2 leds now. How many pairs of 2 leds are you doing?

Mr Sceadwian, Still a total of eight LEDs. 4 sets of two. The board is set up for power to two . Then jump to next board with two, etc.This is not great but the Idea. The diagram below.---Wire,= Board, SC is Socket, R is resistor

--12v---SC=SC---SC=SC---SC=SC---SC=SC Now


--12v --R-- SC=SC
--12v-----------R--SC=SC
--12v----------------------R--SC=SC
--12v---------------------------------R--SC=SC Will be! All four power lines will come from one led,with cap to GRND.
A ground comes of ever SC, to a control head for it to ground.This how it creates patterns.


Thank You