OK.
This thread is becoming everyone's ego ride it seems.
I definitely know how to ask a favor, and have been doing that for many years. Wherever necessary I have provided my schematics, codes and whatever information required to explain my case.
This time though I felt that most will understand when I say "Capacitive" un-isolated power supply.
Here's one attached which I have used.Although it's a photograph of the one I drew on a white board , so please forgive me for not providing a Cad sch.
Secondly , the un-isolated board is going to be fixed in a wall,then there's an overlay ,which is isolated. After which there will be another granite tile over all this assembly. In no way is it electrically available to any user. The proxy sensing will happen at a distance of 10 cm. Even if the tile is touched, it is fully isolated.
Thirdly, the electronic switch used is an electromagnetic relay. So the lamps or any mains operated device is switched through this relay contact.
ronsimpson
Thanks for the information. It's useful.
With all the information on this thread, no one is actually helping me with MY PROBLEM though.
The problem is, that when I reverse the Line & Neutral to the board, the cypress device starts toggling the relay.
Please look for the Cypress device data sheet in my original post.
Finally I would like to say that I understand that this is a technical forum. And people here are helping out each other without any benefits.
Analog Kid , I apologize if I have been a bit overbearing , never my intent.
Although please don't be sarcastic.
It would have been worth the while if you had never brought my 9 years age and how immature I am. Instead if you had directly asked for the schematic, I wouldn't have been the ass in arguing with fellow members.
Thanks and regards