I need to design a temperature sensing circuitry which detects temperature ranging from 0' C to 50' C. The circuits outputs a linearly proportional analog voltage signal ( 0 V to 10 V) for monitoring and data logging purpose.
I have to use LM35DZ temperature sensor and i also have to use OP-Amp_741.
And what is meant by Signal Conditioning Circuit.
How can i compose this circuit by using a software called MULTISM.
Im no expert, but you would probably have to set the opamp up as a voltage follower (this is the signal conditioner), then adjust the gain of the voltage follower so it outputs voltage that meet your parameters. Google "op amp voltage follower" for circuits, and you should check out the datasheet for the LM35 to find out its natural output voltages (only a few volts, if I recall)
Not sure about the MULTISIM, never used it myself.