Qaisar Azeemi
Member
Hi;
1) I am beginner in the PCB Designing and Trying to design my PCB in proteus7. in schemetic Section of proteus(ISIS) mostly VCC and Ground pins are not shown in the IC symbols, for instance in 8051 symbol pin 20=gnd and pin 40=vcc are not shown or in case of PIC16f877A pins 11,12,31 & 32 are not shown. the problem rises head during Layout designing in ARES when i try to connect these pins to VCC or GND they Start blinking with yellow color and indicating fault condition. how can i fix this problem?
2) second problem is with the heat sink packages that i can't find in either ISIS or in ARES. i need to connect heat sinks to regulators 7805 and LM2576T TO220 packages. how to find these and other heatsink packages in proteus?
3)And also how to fill the empty parts of the sheet (places where no layout is present) with copper trace for Ground?
any help will be appriciated.
best regards
Qaisar Azeemi
1) I am beginner in the PCB Designing and Trying to design my PCB in proteus7. in schemetic Section of proteus(ISIS) mostly VCC and Ground pins are not shown in the IC symbols, for instance in 8051 symbol pin 20=gnd and pin 40=vcc are not shown or in case of PIC16f877A pins 11,12,31 & 32 are not shown. the problem rises head during Layout designing in ARES when i try to connect these pins to VCC or GND they Start blinking with yellow color and indicating fault condition. how can i fix this problem?
2) second problem is with the heat sink packages that i can't find in either ISIS or in ARES. i need to connect heat sinks to regulators 7805 and LM2576T TO220 packages. how to find these and other heatsink packages in proteus?
3)And also how to fill the empty parts of the sheet (places where no layout is present) with copper trace for Ground?
any help will be appriciated.
best regards
Qaisar Azeemi
Last edited: