Hi everyone,
I've got a question, I built H-Bridge driver for my motor from this site(Electronic Projects) and I want to conect it to basic stamp II.
I used two 2N3055 transistors and 2 diodes on the ground to switch the inputs, and everything was ok when i assembled it on my breadboard (with 4.7 volts, which is almost the same as output form the basic stamp)but after I've connected to the basic stamp it didn't work as it should, actually it could change the direction but the motor didn't get as much power as it schould. Does anybody have an idea how to fix it.
thanks for reading this
I've got a question, I built H-Bridge driver for my motor from this site(Electronic Projects) and I want to conect it to basic stamp II.
I used two 2N3055 transistors and 2 diodes on the ground to switch the inputs, and everything was ok when i assembled it on my breadboard (with 4.7 volts, which is almost the same as output form the basic stamp)but after I've connected to the basic stamp it didn't work as it should, actually it could change the direction but the motor didn't get as much power as it schould. Does anybody have an idea how to fix it.
thanks for reading this