AtomSoft
Well-Known Member
Need some help not sure how to access BRAM (BLOCK RAM)
I made a small project here but still am getting lost. The project is a simple 2 state device. On state 1 it will write to address 0x00 the byte 0xAA and erase the READ variable/vector
and in state 2 it will read address 0x00 and should report 0xAA back.
I get a Multi-Source error before it does anything in the compile...
I made a small project here but still am getting lost. The project is a simple 2 state device. On state 1 it will write to address 0x00 the byte 0xAA and erase the READ variable/vector
and in state 2 it will read address 0x00 and should report 0xAA back.
I get a Multi-Source error before it does anything in the compile...