Just my luck, got rolled on a used Fluke today. Need a good multimeter. Instead I got another project or likely a lost cause.
This is a graphing model well over a decade old. Fluke does not support it anymore. I highly doubt I can get schematics from them either. All functions seem to work but when you switch to AC or the "component test (test mode for FETs)" modes, the screen just stays blank for the most part. When you push buttons, they all beep and act like things are working but no display. I don't suspect the display is bad though. Works fine in other modes.
there is also a self test on the meter which checks a few things but does not come back with any errors. However, apparently there is supposed to be a graph also displayed during self test which may be more of a display test and it only shows a small line segment and that is it.
Not sure what to make of it. To some extent, it seems there might be a display issue but i know from other modes that the display seems to otherwise work.
This is a graphing model well over a decade old. Fluke does not support it anymore. I highly doubt I can get schematics from them either. All functions seem to work but when you switch to AC or the "component test (test mode for FETs)" modes, the screen just stays blank for the most part. When you push buttons, they all beep and act like things are working but no display. I don't suspect the display is bad though. Works fine in other modes.
there is also a self test on the meter which checks a few things but does not come back with any errors. However, apparently there is supposed to be a graph also displayed during self test which may be more of a display test and it only shows a small line segment and that is it.
Not sure what to make of it. To some extent, it seems there might be a display issue but i know from other modes that the display seems to otherwise work.