First schematic

Status
Not open for further replies.

Adrienne

New Member
**broken link removed**

I intend this to be a simple On off keyswitch type device, I press the button and the carrier frequency turns on. I'm not an expert, but I don't think its going to work yet. Any suggestions?
 
Last edited:
Switch the battery positive lead; not the negative lead. Tie pins 5 & 6 to 7. That will cause it to transmit all the time. Read and follow the part of the data sheet recommendations where it talks about PC layout. Also read the section about the nominal crystal load capacitance.

What are you using to receive/detect the 433.92 MHz signal?
 
First off I love you, and the Max 9930 seems like the viable option. I'll re-draw this then I'll post the next design.
 
The MAX9930 is not a receiver; at best, it might be used as a tiny part of one.
 
A receiver for 433MHz is too complicated, and uses too many specialized components for the average hobbyist. I would **broken link removed**.

I bought both a transmitter and receiver from Abacom for a consulting job I did last year.
 
Well... Lets say I'm a professional in training. I'd prefer a long skinny one. 6 mm wide to fit inside a pen that's 6 inches long.
 
in your diagram you have maked with "?????" you need some thing to be installed there to limit your input or?
 

He already solved the prob. I need a receiver now. I'm looking at micrel quik radios, they don't list the dimensions.
 
I guess you'll also need some space for proper connections such as traces to external components.
 
Status
Not open for further replies.

Similar threads

S
  • Question
My first schematic of a 2-channel relay board
2
Replies
35
Views
5K
eTech
E
E
  • Question
Building a Crystal Radio first time
Replies
16
Views
4K
edteach2
E
B
  • Question
Schematic PCB review - Capacitive Touch Sensor AT42QT1012
Replies
4
Views
2K
Tony Stewart
T
Could use checking of my schematic for Teensy Audio Shield pcb
Replies
17
Views
3K
TonyAme
T
T
Need help checking over schematic for Arduino Nano Audio Sequencer PCB
Replies
5
Views
2K
TonyAme
T
Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…