Electron_23
New Member
Hello everyone,
I am going to use for a project a magnetic encoder, and now I am designing the schematic to later get the PCB manufactured. My question is pretty simple, since I am not familiar at all in PCB design or schematics. The Quadrature A and B pins and index have to be connected to the controller, but do I have to connect them also to a pin header or something? So I can directly measure their outputs if I need it, without passing through the microcontroller.
Thank you very much in advance.
-Electron_23
I am going to use for a project a magnetic encoder, and now I am designing the schematic to later get the PCB manufactured. My question is pretty simple, since I am not familiar at all in PCB design or schematics. The Quadrature A and B pins and index have to be connected to the controller, but do I have to connect them also to a pin header or something? So I can directly measure their outputs if I need it, without passing through the microcontroller.
Thank you very much in advance.
-Electron_23