I need to find out how to wire led`s to a light and sound module, I will post a picture of the module. I am a complete electronic novice. I only need this because its for a Radio control truck I have just bought. I can solder BUT do not understand circuits,series,parallel or understand schematics. I will also post a hand drawn diagram of how I think its done. In my diagram I have only connected 1 led to each of the 12 outputs. I would need several with 2 leds,for headlights and tail lights etc.
The module has connections down the left side "8" is a +, "9 + 10" are also included as outputs 11 + 12
The bottom left of module has a ribbon cable,this has 10 wires,for 10 outputs.
So a total of 12 outputs for lights can be had.
I hope I have explained this so its understandable?
The diagrame I have drawn I can understand, if anyone has the time to draw a similar one showing 5 single led take offs AND 5 double led take offs I will able to work that out,i think!
Sorry if this is all basic stuff but I really know nothing about this stuff and embarrassed to admit it .
The manufacturer is German so I did not get far with language barrier.