dan.gennard
New Member
I am designing an electronic dog kennel. This kennel has a door that will only let the chosen dog into the kennel. It does this using RFID tagging and 1 geared motor to raise and lower the bridge with to micro switches at the top and bottom to cut the motors off. Inside there is a 175w infrared heat lamp that will be linked up to a temperature sensor to keep the kennel at a constant temperature. This will all be linked up to a microcontroller pic16f877a to control the system. Basically I need suggestions into what type of circuit boards and coding that you guys would think are involved in this project. Any and all help will be much appreciated. Cheers guys.
Last edited: