Im looking for the written code to program a PIC 16f877A as an Electronic dice that display number (1 to ) on two seven segment displays.
1) on power on reset both seven segment display must show number one
2)Push button switch must be used to activate the dice roll sequence
3)when push button is pressed the seven segment display must go blank for 250ms and then roll sequence must be displayed with aproximitly 250ms per each display sequence.
4) If push button is not released then end of roll sequence the seven segment diplay must go blank.. The display must remain blank until the push button is released and thn the new random dice numbers must be displayed.
Using MPLAB code using PIC16f877A....
1) on power on reset both seven segment display must show number one
2)Push button switch must be used to activate the dice roll sequence
3)when push button is pressed the seven segment display must go blank for 250ms and then roll sequence must be displayed with aproximitly 250ms per each display sequence.
4) If push button is not released then end of roll sequence the seven segment diplay must go blank.. The display must remain blank until the push button is released and thn the new random dice numbers must be displayed.
Using MPLAB code using PIC16f877A....