Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
The current level of population that are sheeple however has reached a mass greater than the entire human population of millennia's past.
Again, that's a fallacy: "If 90% of everyone believes in proposition X, and only 10% believe in proposition Y, then proposition X must be correct".
...
That however isn't a fact at all. No measurement method has any inherent superiority, C and F can be converted easily albiet there's a nasty repeating decimal involved, this is irrelevant if a calculator of sufficient precision is used. SI units are used in the scientific community because there's already been one nasty error Nasa made with conversion that caused a satellite to fail to enter orbit cause someone forgot to convert properly.Mr RB said:even though the fact is that inches and Fahrenheit are far inferior when analysed by anyone who is open minded.
This does bring up an issue I'm curious about. In the US at least one of the universal standards for construction is studs 16 inches on center, and all lumber is dimensional and based on the foot and fractional inches.. If you were to go to a modern country that is metricized what unit would you find their building supplies in?
QuietMan, your argument against Siemens doesn't make sense, it's an SI derived unit for one which means it's going nowhere. For measuring extremely low resistances it's more human friendly than the Ohm, and even saying that it doesn't matter because Ohm's and Siemens are directly convertible simply. For the measurement of conductance of a fluid especially in industry it is the preferred unit.
Odd, all the industrial controls I've run across use Siemens. It's not renamed, it's a reciprocal value direct based on the Ohm.