Electronic CAD programs

I

Impact

New Member

• Nov 30, 2003

• #1

Hi all,

Can any one out there give me some advise as to which Windows or Linux based Computer Aided Design programs they can recommend for designing PCB layouts, and possibly be able to test the circuit as well?.
I'm not looking for something very advanced, just a program that will enable me to design 2 layered boards, with the possibility of having an overlay for me to screen print onto the boards as well.

Any help would be apreciated.

Best regards.

Impact

 

N

nettron1000

New Member

• Nov 30, 2003

• #2

Message is unavailable.

 

kinjalgp

Active Member

• Nov 30, 2003

• #3

To test your circuits (simulation), you can use B2Spice which has facilty to directly import Eagle files for simulation. However Demo version does not support this feature. You can buy the full version. Its not too costly.

 

eemage21

New Member

• Nov 30, 2003

• #4

Protel

Protel DXP is one of the best ones out there - you can get a demo version on their website, which lasts 30 days. After that you have to spend a couple grand, but I'm sure you can figure out how to get around that problem.

 

kinjalgp

Active Member

• Nov 30, 2003

• #5

I forgot to post the link of B2Spice. Here it is : www.beigebag.com

 

E

Electronics Master

New Member

• Dec 2, 2003

• #6

DON'T WORRY HELP IS ON IT'S WAY

I recommend PCB wizard i use it all the time it gives me hours of enjoyment. I hope you get the same enjoyment i did. IT'S SO FUN!!!!!


:twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted: :twisted:

 

O

olcal

Member

• Dec 28, 2003

• #7

Why dont you try PCB123 ? It can be downloaded free of cost from **broken link removed**

 

SnaRf

New Member

• Dec 29, 2003

• #8

Just another quick question..

Does anyone know of a decent piece of software, that will allow me to place
components on a stripboard (veroboard), and "cut" tracks?

Once I have finished the circuit, I would like to print out bots the TOP and BOTTOM
part of the tripboard?

Thanx