Wond3rboy
Member
Hi i have made this package for the MRF24J40MA transceiver.I want to ask whetehr i have made any mistake with regard to the pins etc.If this is fine i will post a board for this transceiver also.And here are a few questions:
1) Will my Junebug be able to program the 18LF4620( i do think so but just want to confirm)?
2) Are thier any 3 volt low drop out regulators available in packages that are not SMD and are easily available. I can just use normal 3-3.6 v regulators if some one can just give me some chips?
Will these do?
LP2950-30
LP2950-33
They will be used to power the 18LF4620,transceiver.
I have attached the datasheet of the transceiver and the page number describing the package is 7.
1) Will my Junebug be able to program the 18LF4620( i do think so but just want to confirm)?
2) Are thier any 3 volt low drop out regulators available in packages that are not SMD and are easily available. I can just use normal 3-3.6 v regulators if some one can just give me some chips?
Will these do?
LP2950-30
LP2950-33
They will be used to power the 18LF4620,transceiver.
I have attached the datasheet of the transceiver and the page number describing the package is 7.
Last edited: