rs14smith
Member
Hi all,
For some reason my board design in eagle is giving me tons of Angle errors after I run the auto-route feature. I set the grid size to 8mil since I am dealing with a small board. I have attached the eagle files to this thread.
My main concern is, if I send this to a PCB manufacture, will this cause any problems in the creation process?
I attached both the board/schematic files and an image of one of the errors.
For some reason my board design in eagle is giving me tons of Angle errors after I run the auto-route feature. I set the grid size to 8mil since I am dealing with a small board. I have attached the eagle files to this thread.
My main concern is, if I send this to a PCB manufacture, will this cause any problems in the creation process?
I attached both the board/schematic files and an image of one of the errors.