hfireworks
New Member
I have built a capacitive discharge system for my electronic firing system and I have (9) 200vdc 220uf capacitors that charge up from the power supply.
I am needing to use a resister to slowly drain the capacitors once power is turned off. I am using Dale aluminum RH-560 50W 1.5 ohm on my power supply to generate the 200vdc power load.
I would like to use (1) resister to slowly drain all (9) separate power lines, these are individual power lines but I would like to slowly drain all of them with one resister.
What do you recommend, and do you have a diagram that can be put to use?
I am needing to use a resister to slowly drain the capacitors once power is turned off. I am using Dale aluminum RH-560 50W 1.5 ohm on my power supply to generate the 200vdc power load.
I would like to use (1) resister to slowly drain all (9) separate power lines, these are individual power lines but I would like to slowly drain all of them with one resister.
What do you recommend, and do you have a diagram that can be put to use?