I'm doing my first PIC project. I have a PicKit2 and have successfully programmed the PIC (P24HJ128GP202) and everything seems fine when running using the PicKit2 as a debugger. When I remove the PK2 and power the PIC from another 3.3 volt power supply, it doesn't seem to start (software doesn't do the same thing).
I've checked:
1) POR constants and configuration bits
2) power supply output (3.3 volts)
3) MCLR connections -- it's connected like the data sheet says to connect it (resistor to power, cap to ground)
Any ideas? Maybe this is a dumb question, but it has me stumped.
Thanks!
Brad
I've checked:
1) POR constants and configuration bits
2) power supply output (3.3 volts)
3) MCLR connections -- it's connected like the data sheet says to connect it (resistor to power, cap to ground)
Any ideas? Maybe this is a dumb question, but it has me stumped.
Thanks!
Brad