Continue to Site

Welcome to our site!

Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

  • Welcome to our site! Electro Tech is an online community (with over 170,000 members) who enjoy talking about and building electronic circuits, projects and gadgets. To participate you need to register. Registration is free. Click here to register now.

Does anybody using K128 PIC Programmer here ??

Status
Not open for further replies.

aljamri

Member
Hi,

For programming my PIC, I'm using DIY K128 PICmicro programmer from kitsurs.com, since 3 years. I'm looking to test USB supported PIC, which my software back (DIYPACK25) is not supporting. Consulted one of my friends, he adviced me to upgrade my unit. When searched for updates in Kitsurs.com, got nothing, but googling for update, got that it there is DIYPACK26b which seems newer than mine (DIYPACK25), but failed to get the file.

So, anybody having DIYPACK26b please?
 
Thaaaaaaaaaaaaaaanks be80be, I've downloaded it and replaced my old one. One more question, do I have to update anything in the programmer itself? or only the computer software?
 
I don't really no about that I like making programmers and ran across that before
 
the diy 128 programmer has a 16f628 chip on it, I think at one point they upgraded it to a 16f628a chip, that has to be reloaded with the new firmware that comes with the update files. shouldcome with a hex file and a readme file
 
Yes, you are right, if it is new, you need to program the PIC16F628, but later upgrade file comes only to the computer software, or at least that's what I've got. Anyway, I've tried to program some of my old PIC and success ed, When I'll receive my USB PIC I'll try programming them and let you know.

Thanks for all.
 
The 16F628A is not self flashing, you'd need a programmer to update the firmware.

That's what I read to there a clone that is open source and has better software but I don't remember the name of it.

It uses a usb to rs232 bridge and the 16f628a to program your chips it looked nice. works with linux and piklab
 
yep the 16f628a has to be programed. So you take a spare chip load the new firmware on using the diy128 and then swap the chips. That s how I used to do it until I got a pickit 2 programmer. I got a few other programmers around too. its nice to have a spare just incase.
 
Last edited:
which one do you recommend?

It's easy a pickit2. They work with most all pic chips. have nice command line interface, plus it's own ide,

You could make a clone which work just as good or make a cheap clone with out all the bells like the program to go

I never used that option so i made a clone to have a spare good thing to have around

Here a little video of my clone at work
 

Attachments

  • MY_CLONE.PNG
    MY_CLONE.PNG
    107.3 KB · Views: 399
Last edited by a moderator:
Ohhh, is it possible to make it on strip board ? that's make it much much easier.
 
You can use what ever I made with a pcb pref board even in a solder less beard board and it works

I have a pcb design for it to I just redid it for double sided copper and the size is down to 1 1/2 by 2 1/2 inch board
 
Status
Not open for further replies.

Latest threads

New Articles From Microcontroller Tips

Back
Top