With the generator running the fan runs and the display works indicating that both the 12V regulators are working. There is ac voltage across the blue wires going to the inverter but nothing at the 240v outlets or showing on the display. The stepper on the throttle is also inactive. I could not detect any voltage on the three wires on the connector in question. The remote control module has been removed. The pink wire from the ignition switch that went to the remote module has been joined to the wire from the stop button so that the fuel solenoid is off until the ignition switch is in the on position. The 2 pin connector next to the connector in question on my last photo has 2 red wires. I have connected it to a pair that go to generator green and brown I think. Not sure that is is correct or what it is for, but the wires were a suitable length and they were the only connectors not already joined up. It does make for an interesting puzzle when someone else has a go at it and you get the pieces to try to reassemble. Thanks for your assistance already.