HI everyone,
It's the first time I post in this forum, and I would highly appreciate someone helping me out. I am trying to build a CMOS analog switch in Multisim 10; I am using the model shown in Figure 1 in the following link:
**broken link removed**
I've also looked at other sources, and this model seems to be pretty standard. My objective is simply to control a switch with a digital signal to either block (open switch) or let pass (closed switch) an AC signal. I am simulating the digital input with a clock input.
I have been trying to find the bug in my circuit, but it doesn't seem to like any of my suggestions; thus, I need someone else to look at it and hopefully help me find where the error is.
I attach a couple of images of the simulation including the circuit and oscilloscope measurements.
Figure 1. Modelsim Circuitry
**broken link removed**
The following figure displays the output of both transistors wired together as shown in the modelsim circuitry.
Figure 2. Vout (as shown in circuitry) vs. Clock Input
**broken link removed**
The following two images display the ouput of the transistors isolated from each other.
Figure 3. N-channel output V vs. Clock Input
**broken link removed**
Figure 4. P-channel output V vs. Clock input
**broken link removed**
Something that was noticeable for me is the fact that the total output (Figure 1) and the N-channel results (Figure 3) look identical. Aditionally, the
I APPRECIATE ANY HELP YOU GUYS CAN PROVIDE!
It's the first time I post in this forum, and I would highly appreciate someone helping me out. I am trying to build a CMOS analog switch in Multisim 10; I am using the model shown in Figure 1 in the following link:
**broken link removed**
I've also looked at other sources, and this model seems to be pretty standard. My objective is simply to control a switch with a digital signal to either block (open switch) or let pass (closed switch) an AC signal. I am simulating the digital input with a clock input.
I have been trying to find the bug in my circuit, but it doesn't seem to like any of my suggestions; thus, I need someone else to look at it and hopefully help me find where the error is.
I attach a couple of images of the simulation including the circuit and oscilloscope measurements.
Figure 1. Modelsim Circuitry
**broken link removed**
The following figure displays the output of both transistors wired together as shown in the modelsim circuitry.
Figure 2. Vout (as shown in circuitry) vs. Clock Input
**broken link removed**
The following two images display the ouput of the transistors isolated from each other.
Figure 3. N-channel output V vs. Clock Input
**broken link removed**
Figure 4. P-channel output V vs. Clock input
**broken link removed**
Something that was noticeable for me is the fact that the total output (Figure 1) and the N-channel results (Figure 3) look identical. Aditionally, the
I APPRECIATE ANY HELP YOU GUYS CAN PROVIDE!