normad
Member
hey guys.. i want to connect two monostable 555 timers so that the pulse out of one would trigger the other..
as suggested by you guys in my last thread i tried connecting them through capacitor which is set at vcc.. it works on simulation but somehow when i made the circuit it didnt trigger
so is there any alternate method of doing it?
would bringing the capacitor voltage closer to the trigger voltage using a voltage devider help?
i used a 1nf capacitor.. must i use a smaller capacitor?
as suggested by you guys in my last thread i tried connecting them through capacitor which is set at vcc.. it works on simulation but somehow when i made the circuit it didnt trigger
so is there any alternate method of doing it?
would bringing the capacitor voltage closer to the trigger voltage using a voltage devider help?
i used a 1nf capacitor.. must i use a smaller capacitor?