Thanks for the link. I was using the mic in port, didn't know that I was supposed to use line in. However, I don't know if this will work just yet, I will try it out and report back. Fingers crossed.
I have tested my cables out using a media player and when using the mic port, I get quite a lot of noise, but when using the line input it's as clear as anything. When I connected the actual mic to the mic port however, there was no sound at all? Should my method actually work when I use the line in port?
ALSO, if the mic is 600 ohms, and it goes through the line in, would I actually hear anything? If not, let's just say that I recorded the low sound, and played it back through an amp, would it be clear again?