Connecting one component in parallel...to 3 channels?

Hello all,

In the picture attached, there are 3 actuators connected to a driver module. However, I need to connect just one actuator in parallel to three of these channels (i.e. 1,2,3). The reason ...I need a 3.6A drive and each channel only provides 1.2A. Any idea how to wire the single actuator in parallel to these 3 channels?

Thanks!
AA

The is probably not practical way to do that. I woudn't wire them together without contacting the manufacturer first.

The manufacturer was the one who recommended this setup, but they didn't provide details about the wiring (that's my question).

My question is how to wire it correctly in parallel to the 3 channels.

Just connect 1 to 2 to 3 and then to your single load. You will have to change the coding/software/programming of the device such that outputs 1,2,&3 all turn on and off at the same time.