chandantiwary
New Member
hi everyone!!!
i m trying to make a line following robot.i have completed all my connections.earlier i was using uln2803 driver but now i want to switch to L298.can u please illustrate me how to connect the different pins of L298 to the two motors(each of 200 rpm) i m using,besides the connections for voltage and ground.do i need to connect a capacitor and resistor also to the pins of L298.please illustrate me fast.i m waiting with my circuit.
i have used at89c51 and lm324.
i m trying to make a line following robot.i have completed all my connections.earlier i was using uln2803 driver but now i want to switch to L298.can u please illustrate me how to connect the different pins of L298 to the two motors(each of 200 rpm) i m using,besides the connections for voltage and ground.do i need to connect a capacitor and resistor also to the pins of L298.please illustrate me fast.i m waiting with my circuit.
i have used at89c51 and lm324.